Lighting & Controls
Emergency Lighting Inverters & Battery Systems
Central lighting inverters, emergency drivers and battery-backed fixtures, installed, tested and repaired so your egress lighting holds for the full 90 minutes when the power goes out.
When the power fails, emergency lighting has to come on within 10 seconds and keep the path out lit for at least 90 minutes. That depends almost entirely on batteries, and batteries wear out quietly. We install, test, maintain and repair the battery systems behind emergency lighting, from a single battery pack to a building-wide central inverter.
Emergency battery systems we work on
- Central lighting inverters: one battery system feeding emergency lighting circuits across a floor or building, often the cleanest choice where fixtures are architectural or hard to reach
- Emergency LED drivers and battery packs: a battery inside or beside a normal fixture, so the same light serves both everyday and emergency use
- Unit equipment and combination exit/emergency fixtures
- Self-testing and self-diagnostic units that run their own tests and report failures
- Generator-backed emergency circuits with transfer equipment
Testing: monthly and annual
NFPA 101, the Life Safety Code, requires battery-powered emergency lighting to be tested for at least 30 seconds every month and for the full 90 minutes once a year, with written records kept. The annual test is the one that catches a battery that lights for a minute but can't last 90, and it's the test most buildings skip. We run the annual 90-minute discharge test by floor or circuit with the building occupied, replace what fails, retest, and hand you the records the fire marshal will ask for.
Battery replacement programmes
Emergency batteries typically last a few years, not the life of the building. For owners with many fixtures or several buildings, we set up a replacement and testing programme so batteries are swapped on a schedule, not discovered dead during an inspection or an outage.
Central inverter or battery packs?
Battery packs are simple and spread the risk across many fixtures, but they mean many batteries to test and replace. A central inverter puts all the batteries in one room where they're easy to test, maintain and monitor, and it can power fixtures that don't take a battery pack. The right choice depends on the building, the fixture count and who maintains it. We'll lay out the trade-off with real numbers.
For exit signs, egress paths and general emergency lighting, see emergency and egress lighting.
Common questions
How often does emergency lighting have to be tested?
Under NFPA 101, battery-powered emergency lighting must be tested for at least 30 seconds monthly and for the full 90 minutes annually, with written records. Self-testing units can handle the monthly test automatically.
How long do emergency lighting batteries last?
Typically a few years, depending on the battery type and how hot the location runs. The annual 90-minute test is what tells you a battery is done, because a weak battery can still pass a 30-second check.
Do you service central lighting inverters?
Yes. We install, test, replace batteries in and repair central inverter systems, and we can add monitoring so failures are reported before an inspection finds them.
Can you fix emergency lighting deficiencies from a fire inspection?
Yes. Send us the inspection report. We correct the items, retest and give you documentation to close it out.
Are you available after hours?
Yes. We're open 24/7, including emergency calls.
Ready to talk about your project?
Tell us what you need and we will give you a straight answer on scope, schedule and cost. No obligation, and no pressure if it turns out we are not the right fit.